Feig Electronic GmbH TSTPDFSAS User Manual
FEIG ELECTRONIC GmbH Lange Str. 4 D-35781 Weilburg, Germany Tel.: +49 (0) 6471 / 3109-0 Fax: +49 (0) 6471 / 3109-99 www.feig.de Email:
info@feig.de
PD_FSAS_Eng_150409.Doc
TST PD_FSAS
Multiturn Absolute Encoder w/ integrated
Wireless Safety System for industrial doors
– Stationary Unit
Mounting and Startup manual
!
ATTENTION
The content of the door controller manual and particularly the safety instructions
must get note!
must get note!
Connector:
M12, 8- polig,
cable 0,4m 4x2x0.25
cable 0,4m 4x2x0.25
Encoder:
TST PDFSAS-0.0-A
Antenna:
TST FSAS- 0.1-A- circuit
board- Antenna with 0.9m long
coaxial cable
board- Antenna with 0.9m long
coaxial cable
1. Pin connections:
TST
PDFSAS
Controller
FU3P
braun/brown
weiß/white
grün/green
gelb/ yellow
grau/grey
rosa/pink
blau/blue
rot /red
1
2
3
4
5
6
7
8
4
5
6
7
8
GND
+24V
RS485 B
RS485 A
safety edge n o.
breakaway
34
31
36
31
36
35
Si2
6
(not used)
(safety edge 2 optional)
Remarks:
-
For connection shielded cables with M12 A-encoded plug are recommended. The
shield has to be connected to earth ground only on the controller side.
-
The housing of the plug is not allowed to be connected to earth ground.
-
Not used wires must be isolated inside of FU3P
2. Connection image inside with:
reset pins X 3- 2
and X3- 1
coaxial cable with
MCX connector
JST connector 8-pole
battery with connector (see 2.1)
interface cable
2.1 battery change
:
Attention
Disconnecting the battery effects clearing of position values from the
encoder! After reconnecting the battery a RESET must be done. Do not short
or charge the battery. Do not store or operate the system above the
specified temperature range. Connecting the encoder with switched on
supply voltage is not allowed.
encoder! After reconnecting the battery a RESET must be done. Do not short
or charge the battery. Do not store or operate the system above the
specified temperature range. Connecting the encoder with switched on
supply voltage is not allowed.
)
To do an Reset you must make an short cut between the Reset pins
X3-2 and X3-1 for a short moment
3. Mounting of encoder:
magnet holder with magnet
engine shaft or gear box shaft
mounting plate
screw M3 for
magnet holder fixing
15.5 mm / 0.63 inch
17.5 mm / 0.69 inch
...
24.5 mm / 0.965 inch ...
26.5 mm / 1.04 inch
26.5 mm / 1.04 inch
D = 0.49 inch + 0 inch / -0.004 inch
D = 12.0 mm + 0 mm / -0.1 mm
-
The assembling tolerance from shaft center to sensor center is
maximum +/-1 mm (+/- 0.039 inch).
maximum +/-1 mm (+/- 0.039 inch).
-
Torque for M3 screw / magnet holder fixing : maximum 0.4 Nm