Contec DS110-APL User Manual
Settings
FX-DS110-APL
37
To Use Spanning Tree
Spanning tree is enabled when the APL operating mode is ADHOC
mode.
mode.
(1) Start the utility software. From the main menu, select
Configuration, and then select the access point you wish to edit
from the access point name list.
from the access point name list.
*Once an APL on the network has been located using Search,
its settings are stored in a file. It is not necessary to use
Search each time the utility software is started.
its settings are stored in a file. It is not necessary to use
Search each time the utility software is started.
(2) On the Base tab, set the network mode to 'AOHOC(Simple
Mode).'
Or use the DIP switch setting to select ADHOC.
Then make the necessary settings on the Spanning Tree tab.
*Note that all settings other than check boxes may be left at
their factory settings.
their factory settings.
(3) When the settings are complete, select [Write]. The settings
will be valid when the device is rebooted.
To Access the APL from a Different Router
This requires setting the IP parameters on the Base tab (IP Address,
Subnet Mask, Default Gateway). This is also necessary when
configuring a network using the FX-DS110-APE.
Subnet Mask, Default Gateway). This is also necessary when
configuring a network using the FX-DS110-APE.
(1) Start the utility software. From the main menu, select
Configuration, and then select the access point you wish to edit
from the access point name list.
from the access point name list.
*Once an APL on the network has been located using Search,
its settings are stored in a file. It is not necessary to use
Search each time the utility software is started.
its settings are stored in a file. It is not necessary to use
Search each time the utility software is started.
(2) On the Base tab, set the IP parameters (IP Address, Subnet
Mask, Default Gateway).
(3) When the settings are complete, select [Write]. The settings
will be valid when the device is rebooted.