Code 3 Inc. NP130W User Manual

8

 Product does not activate

a. No power to unit

a. Check wiring

b. Fuse blown

b. Replace fuse

c. Ignition not on

c. Turn on ignition

d. Controller cable not connected d. Check cable connection

f.  Damaged or shorted cabling

f.  Check cables for damage

 Unit operates but no light           a. Lamp burned out

a.  Replace lamp

                                                        b. Switch on controller not engaged    b. Push button on controller

Light operates but unit not moving

a. Motor damage

a. Return to Code 3 Inc.

b. Unit hitting obstacle

b. Remove obstacle

Mechanical Dimensions: Width: 7.25"

Depth: 12"

Height:

  lamp down 4"

  lamp raised 12"

360 degrees

10 - 15 VDC

Lamp 'on'

approx. 10A @ 12.8 VDC

Lamp 'off'

approx. 35mA @ 12.8 VDC

Lamp Rating

100 Watts @ 12.8 VDC

To prepare the surface of the Night Probe for finishing wipe it with alcohol

or clean ultrasonically.

Mask off all bearing surfaces before finishing.

Water base and solvent paints based on aliphatic hydrocarbons (mineral

spirits, heptane, hexane and alcohols) have good compatibility with the

Night Probe material.

Chlorinated and aromatic solvents, as well as ketones should generally be

avoided.

Paints used on the Night Probe material can be cured using either air-dry

or bake techniques. Circulating warm air ovens are the best suited and

most economical method of drying.

Curing conditions  will vary depending on the coating and part design. Bake

temperatures of 250 degrees F (121degrees C) are acceptable with Night

Probe material.