PIPO TECHNOLOGY CO. LIMITED P102 User Manual

ˍ˔

 

1.  This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and 
(2)
This device must accept any interference received, including interference 

 that may cause undesired operation. 

2.  Changes or modifications not expressly approved by the party responsible 

for compliance could void the user

ÿs authority to operate the equipment. 

NOTE: This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These 
limits are designedto provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses 
and can radiate radio frequency energyand, if not installed and used in 
accordance with the instructions, may cause harmfulinterference to radio 
communications. However, there is no guarantee that interference will not 
occur in a particular installation. 

If this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and on, 
the user is encouraged to try to correct the interference by one or more of 
the following 

-- Reorient or relocate the receiving antenna. 

  -- Increase the separation between the equipment and receiver. 

  -- Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.       

  -- Consult the dealer or an experienced radio/TV technician for help. 

The device has been evaluated to meet general RF exposure requirement. 
The device can be used in portable exposure condition without RF striction.