PIPO TECHNOLOGY CO. LIMITED P804 User Manual

 

１９

 

1.  This device complies with Part 15 of the FCC Rules. 

 

Operation is subject to the following two conditions: 

 

(1) This device may not cause harmful interference, and 

 

(2) This device must accept any interference received, including 

 

  interference that may cause undesired operation. 

 

2.  Changes or modifications not expressly approved by the party responsible 

for compliance could void the user’s authority to operate the equipment. 

 

NOTE: This equipment has been tested and found to comply with the limits 

for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and on, 
the user is encouraged to try to correct the interference by one or more 
of the following measures: 
-- Reorient or relocate the receiving antenna. 
-- Increase the separation between the equipment and receiver. 
-- Connect the equipment into an outlet on a circuit different 

from that to which the receiver is connected. 

-- Consult the dealer or an experienced radio/TV technician for help. 

 

The device has been evaluated to meet general RF exposure requirement.   
The device can be used in portable exposure condition without RF striction.