RadioFrame Networks Inc DH2 User Manual
Method of Procedure
Installation
Installation
78
RFN_3.1 Beta
on the network connection to the site controller, the SmartJack is incorrectly
configured. Contact the service provider immediately to correct this situation. The
SmartJack switch should be set so that -48V power does not pass through to the
site controller.
configured. Contact the service provider immediately to correct this situation. The
SmartJack switch should be set so that -48V power does not pass through to the
site controller.
If this cable is locally manufactured, crimp the 8-pin connectors as shown in the
following illustration. The wires should be routed straight through. Make sure that
the conductor color is the same at both ends for each conductor of the cable.
following illustration. The wires should be routed straight through. Make sure that
the conductor color is the same at both ends for each conductor of the cable.
Figure 29
T1 interface cable configuration
4.5.2
RFS to iDEN Interface
To connect the RFS to the iDEN Interface, connect the NCU to the iSC-3 using
an Ethernet Media Converter. The Ethernet Media Converter is shipped with
other RadioFrame System equipment in its own container with all the cables
necessary to install it.
an Ethernet Media Converter. The Ethernet Media Converter is shipped with
other RadioFrame System equipment in its own container with all the cables
necessary to install it.
Connecting the NCU to the iSC-3
1 Find these items in the shipping box: one MC15 Ethernet Media Converter,
Allied Telesyn User Guide (contains all product specifications), four rubber
feet, one AC-DC power adapter, one 10BaseT Ethernet cable (straight-
through RJ45-to-RJ45 CAT 5 cable), and one 10Base2 cable (50 ohm coaxial
feet, one AC-DC power adapter, one 10BaseT Ethernet cable (straight-
through RJ45-to-RJ45 CAT 5 cable), and one 10Base2 cable (50 ohm coaxial