RadioFrame Networks Inc RFU7 User Manual
Preparing for the Installation
6
• Do not perform any action that creates a potential hazard to people or makes
the equipment unsafe.
Safety Warnings
Warning!
Only trained and qualified personnel should be allowed to install,
replace, or service this equipment.
replace, or service this equipment.
Warning!
This product relies on the building’s installation for short-circuit (over
current) protection. Ensure that a fuse or circuit breaker no larger than
120 VAC, 15A U.S. (240 VAC, 10A international) is used on the phase
conductors (all current-carrying conductors).
current) protection. Ensure that a fuse or circuit breaker no larger than
120 VAC, 15A U.S. (240 VAC, 10A international) is used on the phase
conductors (all current-carrying conductors).
Warning!
To comply with FCC RF exposure requirements, iDEN antennas must be
installed to provide at least 20cm separation from all persons, with
antenna gain not exceeding 0 dBi.
installed to provide at least 20cm separation from all persons, with
antenna gain not exceeding 0 dBi.
Warning!
Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate
electrical inspection authority or an electrician if you are uncertain that
suitable grounding is available.
absence of a suitably installed ground conductor. Contact the appropriate
electrical inspection authority or an electrician if you are uncertain that
suitable grounding is available.
Warning!
The plug-socket combination must be accessible at all times because it
serves as the main disconnecting device.
serves as the main disconnecting device.