Meisida Electronic Toys Co. Ltd 090727 User Manual
Operation Manual: Please read this manual carefully before operation. Please keep this manual for any needed future reference.
FOR AGE GROUP 8+
WARNINGS
！
WARNINGS
！
Improper use of battery may lead to dangers such as heat, breakage
or leakage, Note the following items
Strictly observe the methods and cautions of the operation manual
Leakage from the battery may cause skin irritation. Recommendation is
to immediately and thoroughly cleanse the irritated area with soap and water.
Do not place battery into water or fire or puncture the battery.
Dispose of any exhausted batteries properly.
Leakage from the battery that has come in contact with the eye may cause
blindness. Cleanse the polluted eye immediately and consult doctor ’s
advice on further treatment
Do not use, charge, or store batteries in places that are in close proximity
or leakage, Note the following items
Strictly observe the methods and cautions of the operation manual
Leakage from the battery may cause skin irritation. Recommendation is
to immediately and thoroughly cleanse the irritated area with soap and water.
Do not place battery into water or fire or puncture the battery.
Dispose of any exhausted batteries properly.
Leakage from the battery that has come in contact with the eye may cause
blindness. Cleanse the polluted eye immediately and consult doctor ’s
advice on further treatment
Do not use, charge, or store batteries in places that are in close proximity
to fire, heat, or moisture.
Not recommended for children under 8
years of age. As with all electrical products, precautions should be
observed during handling and used to reduce the risk of electric shock
observed during handling and used to reduce the risk of electric shock
:
-
-
CAUTION ELECTRIC TOY
Loading & Unloading of the Battery of Remote Controller
1.Using 9V battery
2.Follow the arrow direction to remove the battery cover.
3.See below illustration. Install the 9V battery after checking
2.Follow the arrow direction to remove the battery cover.
3.See below illustration. Install the 9V battery after checking
the positive and negative polarity, replace the battery cover.
4.The duration for continuous operation of the remote controller
battery is 8 hours.
.
Method of Taking the Car out from the Foam.
Illustration I
Illustration II
1 Use a pair of scissors
to snip the string under
the foam. (See Illustration I.)
the foam. (See Illustration I.)
2 Take the Car out from
the foam. (See Illustration II.)
.
.
CAUTIONS
!
CAUTIONS
!
a
.
-
.
.
-
.
.
.
-
,
.
,
.
,
:
.
.
/
M ke sure to switch off after play
Non rechargeable batteries are not to be recharged
Rechargeable batteries are to be removed from the toy before charging.
Rechargeable batteries are only to be charged under adult supervision
Different types of batteries or new and used batteries are not to be mixed
as it may affect operation of the R/C.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the toy and disposed of
properly.
The supply terminals are not to be short circuited
Changes or modifications not expressly approved by the party
responsible for compliance could void the user ’s authority to operate
the equipment
The toy is not to be connected to more than the recommended number
of power supplies
The antenna is not to be inserted into any light sockets or wall outlets.
This equipment has been tested and found to comply with the limits
for a Class B digital device pursuant to Part15 of the FCC Rules
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates
Non rechargeable batteries are not to be recharged
Rechargeable batteries are to be removed from the toy before charging.
Rechargeable batteries are only to be charged under adult supervision
Different types of batteries or new and used batteries are not to be mixed
as it may affect operation of the R/C.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the toy and disposed of
properly.
The supply terminals are not to be short circuited
Changes or modifications not expressly approved by the party
responsible for compliance could void the user ’s authority to operate
the equipment
The toy is not to be connected to more than the recommended number
of power supplies
The antenna is not to be inserted into any light sockets or wall outlets.
This equipment has been tested and found to comply with the limits
for a Class B digital device pursuant to Part15 of the FCC Rules
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation
If this equipment does cause harmful interference to radio or television
which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the
following measures
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation
If this equipment does cause harmful interference to radio or television
which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the
following measures
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from
that to which the receive is connected
Consult the dealer or an experienced radio TV technician for help.
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from
that to which the receive is connected
Consult the dealer or an experienced radio TV technician for help.
Main power switch
ON
OFF
Loading & Unloading of the Batteries of Toy Car
1 Using
x 1.5V AA alkaline
batteries.
2
3 See above illustration. Remove the battery cover by loosening screw,
3 See above illustration. Remove the battery cover by loosening screw,
install the 6pcs AA batteries inside the battery grooves following the positive
and negative polarity as shown on each battery groove, replace the battery
cover over the battery compartment and affix the cover by re-tightening
the screw.
and negative polarity as shown on each battery groove, replace the battery
cover over the battery compartment and affix the cover by re-tightening
the screw.
4 When the AA batteries are exhausted, Turn “OFF” the switch, loosen the
screw on the battery cover, remove the battery cover, take out the exhausted
AA batteries, and dispose of exhausted batteries properly. Reinstall new
AA batteries.
AA batteries, and dispose of exhausted batteries properly. Reinstall new
AA batteries.
.
.
.
.
Turn the switch “OFF”
6
Remarks: 1. Don't connect the toy to the voltage which is higher than recommended.
2. Make sure the loading & unloading of the batteries of the toy car
is under adult supervision.
3. Remove batteries before storing car for extended period of time.
Cautions in Operation
Caution: Don’t insert fingers or other objects
into the gaps between the wheel and car body.
Operation should only be performed under
close adult supervision. Don’t touch the
wheels or the front frame joining when the car
into the gaps between the wheel and car body.
Operation should only be performed under
close adult supervision. Don’t touch the
wheels or the front frame joining when the car
switch is turned “ON”.
Caution: Don’t brandish the antenna or point
the antenna toward anyone’s face as accidental
the antenna toward anyone’s face as accidental
injury could occur in the event the antenna tip
went into the eye. Should the antenna be
damaged in any way, please be sure to replace
it due to the possibility of injury. Do not place
the antenna into any socket so as to avoid
it due to the possibility of injury. Do not place
the antenna into any socket so as to avoid
electric shock.
Caution: Don’t play with the car on roads or
in crowded places to avoid accident or injury.
Also, don’t run the car on the restive places
such as a wet or sandy surface as this shall
lead to breakdown of the toy.
in crowded places to avoid accident or injury.
Also, don’t run the car on the restive places
such as a wet or sandy surface as this shall
lead to breakdown of the toy.
Indication for the Function of Remote Controller
Forward
Forward Left
Backward Left
Backward Right
Forward Right
Backward
Cautions:
1. The car runs in fast speed, please make sure to keep
1. The car runs in fast speed, please make sure to keep
others away to avoid crash or damage to car.
2. Make sure not to insert fingers or other objects into the gaps
between wheels & axles when playing to avoid any accidental injury.
between wheels & axles when playing to avoid any accidental injury.
For more information, visit
www.1BADDRIDE.com
© 2009 Professional Collectibles Ltd.
Made in China