Pineapple Technology Inc. DTXPRO2300U User Manual

Page of 73
PINEAPPLE TECHNOLOGY, INC.                               V.3.  DXDPRO-10U APPLICATIONS AND INSTALLATION 
DXDPRO-10U MODULATOR MANUAL 
 
THE INFORMATION PROVIDED HEREIN IS PINEAPPLE TECHNOLOGY INCORPORATED PROPRIETARY INFORMATION AND 
CANNOT BE COPIED OR DISTRIBUTED WITHOUT PRIOR AUTHORIZATION 
18 
 
V.3 DXDPRO-10U APPLICATIONS AND INSTALLATION 
A.  APPLICATIONS   
 
The DXDPRO Modulator line was developed to process ASI or SMPTE-310M transport streams and 
convert them into an ATSC Compliant signal for Television Broadcast transmission.  Additional broadcast 
formats are available i.e., H/M, xxx, and others.   
 
Models available in this family of products include: 
 
a.  DXDPRO-MB - This is 
the ―BASE MODEL‖.  This modulator can be used on all channels for 
UHF, VHF High Band, or VHF Low Band TV Channels between 45 and 900 MHz. 
 
b.  DXDPRO-MBR - Built in receiver for Translator/Transposers with 0 dBm output on any channel 
between 45 and 900 MHz. 
 
c.  DXDPRO-10U - Transmitter modulator for UHF TV with 10 W average digital power output.  
Excellent for high power transmitter. 
 
d.  DXDPRO-10UR - Built in receiver for Translator/Transposer with 10 W average digital power 
output on UHF TV Channels. 
 
e.  DXDPRO-10VH - Transmitter modulator for VHF High Band TV Transmitter with 10 W average 
digital power output.  Excellent for high power transmitters. 
 
f. 
DXDPRO-10VHR Built in receiver for Translator/Transposers with 10 W average digital power 
output on all VHF High Band TV Channels. 
 
B. 
TRANSMITTER INSTALATION
 
The modulator is enclosed in a convenient one (1) RU 19 inch package.  This allows installation into most 
standard rack.  Do not use the front panel to hold up the modulator in the rack.  RACK SUPPORT RAILS 
MUST BE USED
.  All cable connections are located on the rear of the chassis.  Several cable types are 
used to make necessary connections.  Please review the following list;
 
1.  SMA 50 ohm connectors with RG 223 cable should be used for linear and non-linear connections 
between the modulator and the directional couplers located before and after the mask filter.  A 
similar set of cables should be used to connect the forward and reflected power sample for the 
Modulators power meter. 
2.  Type N 50 ohm connector with  RG 223 or RG 8 cable can be used for the RF Output 
3.  DB15 cable for alarm input 
4.  DB9 cable for analog and control functions 
5.  AC Inlet (filtered) type 
6.  Molex 3 p connector of 48 VDC Auxiliary input  
7.  RJ-45 Ethernet connection 
8.  GPS 1pps or 10 MHz BNC 75 ohm connections 
9.  ASI OR SMPTE-310M BNC 75 ohm connections