All-Line Inc RE0012 User Manual

Page of 2
INFORMATION TO USER:
 
CAUTION:  Changes or modifications not expressly approved by All-line are
could void the user's authority to operate this equipment.
 
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more
RE0012 – System Remote Control
Appearanc
e
INTRODUCTION :
This remote can be used with 6 channel power control
switched. For example a outdoor power switch (our model
RE0011) and indoor power switch (our model 2023) etc.
With the remote Control system you can operate electrical
appliances (e.g. lamps, coffee-maker etc.) in or around your
house via the remote control.
BATTERY INSTALLATION :
Your new remote controller use one “ “ battery (Alkaline
battery recommended). Open the battery cover on the back
side and install battery follow the correct polarity (+) and (-
) marked.
Note :
 
Remove the battery when the remote control is not
going to be used for a long period time.
 
Battery in the remote control should be replaced if the
transmission range of the remote control reduces
drastically.
Installing
battery
OPERATION :
 
To operate the 6 channel power switch ON/OFF by pressing the toggle switch
with unit code engraved on the key knob.
 
Press the toggle switch to turn ON and repeat to turn OFF the corresponsive
power switch.