ORCOM Co. Ltd OP-42TN User Manual
The mains lead is attached to the rear of your PDP.
If you have purchased this PDP in the United Kingdom, refer to page 45
for further instructions on plug wiring.
for further instructions on plug wiring.
Plug the mains lead into an appropriate socket.
The Standby indicator on the front of the PDP lights up.
The Standby indicator on the front of the PDP lights up.
NOTE : The main voltage is indicated on the rear of the PDP and
the frequency is 50 or 60Hz.
Press the “I / ” button on the front of the PDP
(or POWER )button on the remote control)to switch the PDP on.
The programme that you were watching last is re-selected
automatically.
(or POWER )button on the remote control)to switch the PDP on.
The programme that you were watching last is re-selected
automatically.
NOTE: If you have not yet stored any channels,No clear picture
appears.Refer to “Storing Channels Automatically ” on
page 13 or “Storing Channels Manually ” on page 14.
page 13 or “Storing Channels Manually ” on page 14.
To switch your PDP off,press the “I / ” button again.
Switching On and Off
Placing in Standby Mode
11
1
2
3
Your PDP can be placed in Standby mode, in order to reduce the Power
consumption.
The Standby mode can be useful when you wish to interrupt viewing
temporarily (during a meal, for example).
consumption.
The Standby mode can be useful when you wish to interrupt viewing
temporarily (during a meal, for example).
. Press the POWER( )button on the remote control.
The screen is turned off and the Standby indicator on the front of the
PDP lights.
PDP lights.
To switch the PDP back on,simply press the POWER( ) button
again.
again.
1
2
OP-42TN1U/42TN2U(GB) 2004.10.1 10:37 AM ˘
` 11 mac001 1200DPI 100LPI