Netgear 08200086 User Manual

Installation and Configuration

2-13

2. Connect an Ethernet cable from your NETGEAR Wireless-N Access Point to a LAN port on 

your router, switch, or hub. Connect the power adapter to the wireless access point and plug 
the power adapter into a power outlet. The PWR, LAN, and Wireless LAN LEDs and should 
light up

Tip: Before mounting the WN802Tv2 in a high location, first set up and test the 

WN802Tv2 to verify wireless network connectivity.

Before you begin installation, check to make sure that the four screws selected to secure the 
brackets fit flush within the molding of the bracket. An illustration of the installation steps is 
shown in 

. 

To install the wireless access point mounting brackets:

1. Place the bottom bracket on the wall where you want to install the WN802Tv2. Securely screw 

the bottom bracket into the wall, making sure the screws are flush with the bracket (Step 1).

2. Snap the WN802Tv2 into place on the bottom bracket (Step 2). The tabs on the bottom of the 

bracket will snap into the slots on the bottom of the WN802Tv2.

3. Firmly secure the top bracket onto the WN802Tv2 and attach the bracket with two additional 

screws (Step 3). Ensure that the bracket flange engages with the top lip of the WN802Tv2 
before screwing in the bracket.

Should you need to remove the WN802Tv2, unscrew the top bracket, and then unsnap the 
WN802Tv2 from the bottom bracket. Never try to remove your wireless access point before 
removing the top bracket.