Netgear 11100154 User Manual

Click Apply to save your settings.

The wireless access point provides a built-in DHCP server for wireless clients only, which can 
be especially useful in small networks. When the DHCP server is enabled, the wireless 
access point provides preconfigured TCP/IP configurations to all connected wireless stations.



Select Configuration > IP > DHCP Server Settings. The DHCP Server Settings screen 
displays:

Specify the fields as explained in the following table:

Select the DHCP Server check box to enable the DHCP server. Use the default settings or specify the pool 
of IP addresses to be assigned by setting the starting IP address and ending IP address. These addresses 
should be part of the same IP address subnet as the wireless access point’s LAN IP address.

DHCP Server VLAN ID

Enter the DHCP server VLAN ID. The VLAN ID range is between 1 and 4094.

Starting IP Address

Enter the first address in the range of IP addresses to be assigned to DHCP 
clients. The default address is 192.168.1.02.

Ending IP Address

Enter the last address in the range of IP addresses to be assigned to DHCP 
clients. The default address is 192.168.1.50.

Subnet Mask

Enter the subnet mask to be used by DHCP clients. The default mask is 
255.255.255.0.

Gateway IP Address

Enter the IP address of the default routing gateway to be used by DHCP clients. 
The default address is 192.168.0.1.