Netgear wgt624v3 User Manual

8-2

Troubleshooting

When the router is turned on, the lights turns on for about 10 seconds and then turn off. If all the 
lights stay on, there is a fault within the router.

If all lights are still on one minute after power up:

•

Cycle the power to see if the router recovers.

•

Clear the router’s configuration to factory defaults. This will set the router’s IP address to 
192.168.0.1. This procedure is explained in 

.

If the error persists, you might have a hardware problem and should contact technical support.

If either the LAN lights or Internet light do not light when the Ethernet connection is made, check 
the following:

•

Make sure that the Ethernet cable connections are secure at the router and at the hub or 
workstation.

•

Make sure that power is turned on to the connected hub or workstation.

•

Be sure you are using the correct cable:

— When connecting the router’s Internet port to a cable or DSL modem, use the cable that 

was supplied with the cable or DSL modem. This cable could be a standard 
straight-through Ethernet cable or an Ethernet crossover cable.