Balboa Instruments Inc. SPAHOME1 User Manual
Mode
This button is used to switch between standard, economy, and sleep modes. Press MODE to enter mode
programming, press “Down” to cycle through to desired mode (LCD flashes until confirmed), then press
MODE to confirm selection.
programming, press “Down” to cycle through to desired mode (LCD flashes until confirmed), then press
MODE to confirm selection.
Standard mode maintains the desired temperature. Note that the last measured spa temperature displayed is
current only when the pump has been running for at least 2 minutes. “Std” will appear on the display momentarily
when you switch into Standard Mode.
current only when the pump has been running for at least 2 minutes. “Std” will appear on the display momentarily
when you switch into Standard Mode.
Economy mode heats the spa to the set temperature only during filter cycles. “Ecn” will appear solid when the
temperature is not current and will alternate with the temperature when the temperature is current.
temperature is not current and will alternate with the temperature when the temperature is current.
Pressing SYNC/JETS while in Economy mode puts the spa in
Standard-In-Economy mode, (“SE”) which
operates the same as Standard Mode, then reverts to Economy Mode automatically after 1 hour. Press DOWN or
UP followed by LIGHT to revert the mode to Economy immediately.
UP followed by LIGHT to revert the mode to Economy immediately.
Sleep mode heats the spa to within 20°F (11°C) of the set temperature only during filter cycles. “SLP” will appear
on the display until mode is changed.
on the display until mode is changed.
Sync/Jets
The SYNC/JETS button on the SpaMonitor works like the JETS1 button on your main panel (or like the
JETS button if your main panel has only one Jets button).
JETS button if your main panel has only one Jets button).
Page 4