Manualsbrain.com
  1. Manuals
  2. Brands
  3. WebGate Inc.
  4. WB101X-WG1K
  5. User Manual

WebGate Inc. WB101X-WG1K User Manual

Download
Page of 30
 
 
WebEye 
WebEye  B101
B101 User’s Guide 
26 
you listed in a group, a dome camera travels.   
• 
Click  ‘Add/Change ’ button 
• 
In ‘Curren t Group Member’ panel, all  registered  preset points appear. At the bottom of this window, you 
may check if the selected number is occupied or not. 
 
Mode 
There are three modes like ‘Normal Mode’, ‘Swing Mode’, and ‘Group Mode ’. 
• 
Under normal mode, user may c ontrol PTZ mechanism of a dome camera with corresponding buttons in 
control panel. If you activate  ‘Give/Take Mode ’ each user is to be  permitted to control the PTZ 
mechanism for a certain period of time on a first-come-first-served basis.   
• 
If swing mode is  selected, the connected dome camera swings between the designated points. Time 
duration of  ‘Wait (some) seconds ’ signifies the same meaning that of group mode.   
• 
If group mode is selected, the dome camera travels among listed preset point according to the listed order.   
 
10) Serial Port Configuration  
This page is to select a communication 
protocol among listed ones. 
 
(1) Serial Port Selection 
Administrator selects a serial port to 
configure. WebEye B101 has three serial 
ports.  ‘Serial #1’ and  ‘Serial #2’  are 
RS232C interface ports, and ‘Serial #3’ is a RS422/RS485 interface port.   
 
(2) Select Attached Device 
Administrator selects a communication protocol that an attached external device satisfies among already listed 
protocols. WebGate has listed protocols of Philips, Pelco (P and D), Sensormatic, and Video Technical.   
Audio Device 
This protocol is for WebEye A10, which is an audio transmission device connected to WebEye B101.   
 
Control Parameters  
With listed protocols of Philips, Pelco, Sensormatic and VT, you may also configure its control parameters 
such as  ‘Baud Rate’,  ‘Stop Bits’,  ‘Data Bits ’, and  ‘Parity Check’ according to connected dome camera 
settings. 
 
Manual Setting 
If your mechanism doesn’t use any of already listed protocols, you may define the protocol manually by 
selecting ‘Manual Setting ’ and set parameters through ‘Control Parameters ’ and ‘PTZ CMD’ menus. 
 
11) Digital I/O Con figuration 
This page is to  configure  digital input status . 
This is related with E-mail and FTP 
applications and PTZ preset points. 
 
(1) Device Type for Input Ports 
Administrator defines active state of 4 digital 
input ports. If you connect normal open type