Lenbrook Industries Limited VISO1AP User Manual

Caution Marking and rating plate is located at bottom enclosure of the apparatus.

CAUTION 
Danger of explosion if battery is incorrectly replaced. Replace only with the same or 
equivalent type. 

An appliance with a protective earth terminal should be connected to a mains outlet 
with a protective earth connection.

NOTE
This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed to 
provide reasonable protection against harmful interference in a residential installation.  
This equipment generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference 
to radio communications.  However, there is no guarantee that interference will not 
occur in a particular installation.  If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the 
following measures:

•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected.

•  Consult the dealer or an experienced radio/ TV technician for help. 

“This Class B digital apparatus complies with Canadian ICES-003.”

This device complies with Industry Canada license-exempt RSS-210.  Operation is 
subject to the following two conditions: (1) this device may not cause Interference, 
and (2) this device must accept any interference, including interference that may 
cause undesired operation of the device.

•  no naked flame sources such as lighted candles should be placed on the 

apparatus;

•  the use of apparatus in tropical climate

This device complies with Part 15 of the FCC rules. Operation is subject to the 
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may 
cause undesired operation.

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN 
EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE 
PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE 
PRODUCT’S ENCLOSURE THAT MAYBE OF SUFFICIENT MAGNITUDE TO 
CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS 
INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT 
OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE 
LITERATURE ACCOMPANYING THE APPLIANCE.

CAUTION REGARDING PLACEMENT
To maintain proper ventilation, be sure to leave a space around the unit (from the largest 
outer dimensions including projections) that is equal to or greater than shown below.
 

Left and Right Panels: 10 cm

Rear Panel: 10 cm

WARNING
If this product is used at 240VAC, a suitable attachment plug should be used.

FCC RF RADIATION EXPOSURE STATEMENT
Caution: To maintain compliance with the FCC’s RF exposure guidelines, place the VISO 
1 AP at least 20cm from nearby persons.

Hereby, Lenbrook Industries Limited, declares that 
this Wireless Music System is in compliance with 
the R&TTE Directive (1999/5/EC), Low Voltage 

Directive (2006/95/EC) and other essential requirements. The declaration of conformity 
may be consulted at www. lenbrook.com/DoC.

At the end of its useful life, this product must not be disposed of with 
regular household waste but must be returned to a collection point for 
the recycling of electrical and electronic equipment. The symbol on the 
product, owner’s manual and packaging, point this out. 

The materials can be reused in accordance with their markings. Through re-use, 
recycling of raw materials or other forms of recycling of old products, you are 
making an important contribution to the protection of our environment. Your local 
administrative office can advise you of the responsible waste disposal point.

Batteries bearing any of these symbols indicate that 
they should be treated as “separate collection” and not 
as municipal waste. It is encouraged that necessary 
measures are implemented to maximize the separate 
collection of waste batteries and to minimize the disposal 
of batteries as mixed municipal waste.

End-users are exhorted not to dispose of waste batteries 
as unsorted municipal waste. In order to achieve a 
high level of recycling waste of batteries, discard waste 
batteries separately and properly through an accessible 

collection point in your vicinity. For more information about collection and recycling 
of waste batteries, please contact your local municipality, your waste disposal service 
or the point of sale where you purchased the items.

By ensuring compliance and conformance to proper disposal of waste batteries, 
potential hazardous effects on human health is prevented and the negative impact of 
batteries and waste batteries on the environment is minimized, thus contributing to 
the protection, preservation and quality improvement of the environment.

 

 

 

 

 

 

23. Battery Disposal - When disposing of used batteries, please comply 

with governmental regulations or environmental public instruction’s 
rules that apply in your country or area. Batteries (battery pack or 
batteries installed) must not be exposed to excessive heat such as 
sunshine, fire or the like.  

24. Safety Check - Upon completion of any service or repairs to this 

product, ask the service technician to perform safety checks to 
determine that the product is in proper operating condition. 

25. Wall or Ceiling Mounting - The product should be mounted to a wall 

or ceiling only as recommended by the manufacturer.

The lightning flash with arrowhead symbol, within an equilateral 
triangle, is intended to alert the user to the presence of 
uninsulated “dangerous voltage” within the product’s enclosure 
that may be of sufficient magnitude to constitute a risk of 
electric shock to persons

The exclamation point within an equilateral triangle is intended 
to alert the user to the presence of important operating 
and maintenance (servicing) instructions in the literature 
accompanying the appliance.

 

CAUTION REGARDING PLACEMENT 
To maintain proper ventilation, be sure to leave a space around the unit 
(from the largest outer dimensions including projections) than is equal to, 
or greater than shown below. 
  Left and Right Panels: 10 cm 
  Rear Panel: 10 cm 
  Top Panel: 50 cm 

IMPORTANT INFORMATION TO UK CUSTOMERS
DO NOT cut off the mains plug from this equipment. If the plug fitted is 
not suitable for the power points in your home or the cable is too short 
to reach a power point, then obtain an appropriate safety approved 
extension lead or consult your dealer. If nonetheless, the mains plug is 
cut off, REMOVE THE FUSE and dispose of the PLUG immediately, to avoid 
possible shock hazard by inadvertent connection to the mains supply. If 
this product is not provided with a mains plug, or one has to be fitted, then 
follow the instructions given below: 

IMPORTANT 
DO NOT make any connection to the larger terminal which is marked 
with the letter ‘E’ or by the safety earth symbol or colored GREEN or GREEN 
AND YELLOW. The wires in the mains lead on this product are colored in 
accordance with the following code: 
  BLUE - NEUTRAL 
  BROWN - LIVE 

As these colors may not correspond with the colored markings identifying 
the terminals in your plug, proceed as follows: 
•  The BLUE wire must be connected to the terminal marked with the 

letter ‘N’ or colored BLACK. 

•  The BROWN wire must be connected to the terminal marked with the 

letter ‘L’ or colored RED 

•  When replacing the fuse, only a correctly rated and approved type 

should be used, and be sure to re-fit the fuse cover. 

 

This product is manufactured to comply with the radio 
interference requirements of EEC DIRECTIVE 2004/108/EC.

At the end of its useful life, this product must not be disposed 
of with regular household waste but must be returned to a 
collection point for the recycling of electrical and electronic 
equipment. The symbol on the product, user’s manual and 

packaging point this out. 

The materials can be reused in accordance with their markings. Through 
re-use, recycling of raw materials, or other forms of recycling of old 
products, you are making an important contribution to the protection of 
our environment. 

Your local administrative office can advise you of the responsible waste 
disposal point. 

RECORD YOUR MODEL NUMBER (NOW, WHILE YOU CAN SEE IT) 
The model and serial number of your new C 355BEE are located on the 
back of the cabinet. For your future convenience, we suggest that you 
record these numbers here: 

 

Model number : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 

Serial number :  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 

 

NAD is a trademark of NAD Electronics International, a division of Lenbrook Industries Limited

Copyright 2008, NAD Electronics International, a division of Lenbrook Industries Limited 

0979

NAD is a trademark of NAD Electronics International, a division of Lenbrook Industries Limited

Copyright 2013, NAD Electronics International, a division of Lenbrook Industries Limited

VISO1AP_QS_SAFETY_V08 - MAY 2013