Radwin Ltd. AMWL1530 User Manual
Chapter 4 Operation
WinLink 1000 Installation and Operation Manual
Exiting WinLink Manager (Exit button)
•
Menu bar
File Menu – Log off, and exit
Configuration – use for link configuration, individual site
configuration or link installation
configuration or link installation
Tools – set preferences, event log handling, change password
Maintenance – Loopbacks, system reset.
•
Link details pane – summarizes information on the radio frequency,
air interface rate, type of TDM service, and IP details of the local
and remote WinLink 1000 units.
air interface rate, type of TDM service, and IP details of the local
and remote WinLink 1000 units.
•
Monitor pane – displays the link quality between local and remote
devices and the following statistics:
devices and the following statistics:
Local/remote received traffic rate (in kbps)
Local/remote received frames rate (in fps)
Radio link status
E1 or T1 link status
Radio signal strength (RSS) in dBm
Block error rate
•
Event log – stores both alarms and traps:
Alarms and traps also generated by NMS (e.g. counter clear,
device unreachable, etc.)
device unreachable, etc.)
•
Traps:
Monitoring for radar activity on channel <frequency> GHz. –
Apply to DFS/TPC products only. T trap is issued when the ODU
starts the looking for radar.
Apply to DFS/TPC products only. T trap is issued when the ODU
starts the looking for radar.
Radar activity was detected in <site>, on channel <frequency>
GHz. Apply to DFS/TPC products only. The ODU detected radar.
The channel is prohibit for 30 minutes.
GHz. Apply to DFS/TPC products only. The ODU detected radar.
The channel is prohibit for 30 minutes.
Transmitting on channel <frequency> GHz. – The ODU started
transmission on a channel.
transmission on a channel.
Channel scanning in progress. The ODU start searching the
remote ODU in all channels.
remote ODU in all channels.
Configuration problem detected. Link installation required.
4-6
Managing WinLink 1000