Radwin Ltd. AMWL1530 User Manual
Chapter
5 Diagnostics and Troubleshooting
WinLink 1000 Installation and Operation Manual
5-10
Frequently Asked Questions
Q: Can WinLink 1000 be managed and configured via Telnet?
A: No. Use only the WinLink 1000 software manager.
A: No. Use only the WinLink 1000 software manager.
Q: After reselection Channel Reselection link is not established for long
time. How can I recover the link?
time. How can I recover the link?
A: Click "cancel", then open the site configuration dialog and set the
unit to install mode. The remote side of the link shall enter install
mode on the installation channel.
unit to install mode. The remote side of the link shall enter install
mode on the installation channel.
Services
Q: What is the actual Ethernet data rate and maximum throughput?
A: The Max net throughput of the WinLink 1000 is Full Duplex 18
Mbps.
A: The Max net throughput of the WinLink 1000 is Full Duplex 18
Mbps.
The WinLink 1000 is a symmetrical system
Q: Does WinLink 1000 withhold any MAC Addresses?
A: The WinLink 1000 is a layer 2 Bridge (VLAN transparent). The built
in switch contains a MAC Address table up to 2047.
A: The WinLink 1000 is a layer 2 Bridge (VLAN transparent). The built
in switch contains a MAC Address table up to 2047.
Q: What are the BER values expected in the WinLink 1000 link?
A: 1E-10 (according to BER sensitivity threshold)
A: 1E-10 (according to BER sensitivity threshold)
Antennas and Cables
Q: Can I use any category 5e cable in order to connect the IDU and
ODU?
A: The cable should be suitable for outdoor use, and shielded
Category 5e.
ODU?
A: The cable should be suitable for outdoor use, and shielded
Category 5e.
Competitve
Note