Radwin Ltd. RW2024 User Manual

RADWIN 1000/2000 User Manual

Version  2.2e

3-13

6. Make a horizontal sweep of 180 degrees with the site A antenna so that 

the strongest signal from site B can be detected.

7. Slowly turn the site A antenna back towards the position of site B, listen-

ing to the tone until the best signal is reached. See the following figure 
for audible signal variations.

Figure 3-11: Beep Sequence for antenna alignment

8. Secure the site A antenna to the pole/wall.

9. Repeat steps 4 to 8 for site B.

¾

1. Using a coax cable with N-Type connectors, connect one antenna to the 

ANT 1 connector of the ODU.

2. Follow the steps 3 to 7 above to align the antenna connected to the ODU 

connector ANT 1 on both sides of the link.

3. On both sides of the link, disconnect the antenna connected to the ODU 

connector ANT 1. Connect the other antenna to connector ANT 1 and fol-
low the steps 3 to 7 above to align the second antenna.

4. Secure the antennas to the pole/wall.

5. Restore one of the antennas to ANT 2 on both sides of the link.

• Three beeps and a pause is 'best signal so far'
• Two beeps and a pause is 'signal quality increased'
• One beep and pause is 'no change in signal'
• Long beep and short pause is 'signal quality decreased'
• One beep and a long pause is 'no air link'
• Any other signal does not relate to antenna alignment

The ODU buzzer only works on the radio connected to the ANT 1 connector 
marked 

. You will therefore need to use ANT 1 to align both antennas 

in turn. Upon completion of the alignment procedure, you may connect the 

two antennas to ANT 1 and ANT 2 connectors.