Radwin Ltd. RW2030 User Manual
RADWIN 1000/2000/5000 User ManualVersion 2.6.50p1
5-1
Chapter 5
Configuring the Link
This chapter describes the link configuration procedure, which is performed
after the installation of both sides of the RADWIN 1000/2000/5000 link, as
set out in chapters
after the installation of both sides of the RADWIN 1000/2000/5000 link, as
set out in chapters
and
.
Link configuration uses a Link Configuration Wizard to redefine the configu-
ration parameters and fine-tune an operational link. Both sides of the link
are configured simultaneously.
ration parameters and fine-tune an operational link. Both sides of the link
are configured simultaneously.
The following parameters are configured using the Link Configuration Wiz-
ard:
ard:
• System parameters
• Channel settings
• Transmission power and antenna settings
• Service parameters
• Channel settings
• Transmission power and antenna settings
• Service parameters
Link Configuration: Getting Started
The Main Window of the RADWIN Manager
Ensure that the RADWIN Manager is running.
The main window should look similar to that in
: