Radwin Ltd. RW2058U User Manual

RADWIN 1000/2000/5000 User ManualVersion  2.5.30p3

iv

Indoor Units comply with part 15 of the FCC rules and ICES-003 standard. Operation is 
subject to the following two conditions:

(1) These devices may not cause harmful interference.

(2) These devices must accept any interference received, including interference that may 
cause undesired operation.

This Class B digital apparatus complies with Canadian ICES-003.

Applicable requirements of National Electrical Code (NEC), NFPA 70; and the National 
Electrical Safety Code, ANSI/IEEE C2, must be considered during installation.

NOTES:

1. A Primary Protector is not required to protect the exposed wiring as long as the exposed 
wiring length is limited to less than or equal to 140 feet, and instructions are provided to 
avoid exposure of wiring to accidental contact with lightning and power conductors in 
accordance with NEC Sections 725-54 (c) and 800-30.

In all other cases, an appropriate Listed Primary Protector must be provided. Refer to Articles 
800 and 810 of the NEC for details.

2. For protection of ODU against direct lightning strikes, appropriate requirements of NFPA 
780 should be considered in addition to NEC.

3. For Canada, appropriate requirements of Section 60 of the CEC 22.1should be considered 
as applicable.

4. E1/T1 ports are intended for connection to indoor lines only and are not exposed to 
outdoor plants.

The antenna used for this transmitter must be installed to provide a 

separation distance of at least 225cm from all persons and must not be co-

located or operated in conjunction with any other antenna or transmitter.

This product was tested with special accessories - indoor unit (IDU or 

PoE), FTP Cat 5e shielded cable with sealing gasket, 12 AWG grounding 

cable - which must be used with the unit to insure compliance.