Averatec 3300 User Manual

Using the BIOS Setup Utility — Change User Password 

 

With a User password, you can enter the Setup Utility and change or 
remove the User password, but you cannot enter the Setup Utility and 
change or remove the Supervisor password, nor enable diskette 
access if it has been disabled. 

A supervisor password must be set before a lower-level user 
password can be set. After selecting Change Supervisor Password, 
press  Enter. You will be prompted for the new password, and then 
again to verify it. Type in 6 or fewer keystrokes. If you make an error, 
press Esc to start over.  

The main page provides the system parameters for you to reset the 
CMOS to default settings. After you enter this page, select the Load 
Optimal Defaults: 

 

 

 

 

Load Optimal Defaults? 

Select [OK] to reset the CMOS to default settings. 

 

 Save Settings   
 and Exit 

Select this option to save changes to the field 
values, and restart the computer using the new 
values. (Pressing F10 from any of the menu 
screens also allows you to save settings and exit.) 

 Exit Without  
 Saving 

Select this option to discard any changes you have 
made to the field values, and restart the computer 
using the old values.