Fi Win Inc WM68 User Manual

 

61 

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and

2) The transmitter module may not be co-located with any other transmitter or antenna.

As long as 2 conditions above are met, further transmitter test will not be required. However, the 

OEM integrator is still responsible for testing their end-product for any additional compliance 

requirements required with this module installed (for example, digital device emissions, PC  

peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop 

configurations or co-location with another transmitter), then the FCC authorization is no longer 

considered valid and the FCC ID can not be used on the final product. In these circumstances, the  

OEM integrator will be responsible for re-evaluating the end product (including the transmitter)

 

and obtaining a separate FCC authorization. 

 

End Product Labeling  

 

This transmitter module is authorized only for use in device where the antenna may be installed 

such that 20 cm may be maintained between the antenna and users (for example access points,  

routers, wireless ADSL modems, and similar equipment). The final end product must be labeled in a

 

visible area with the following: "Contains TX FCC ID: Q5SWM68".

Manual Information for End Users

 

for end users must include the following information in a prominent location:

"IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this 

transmitter must be installed to provide a separation distance of at least 20 cm from all persons