KROHNE FMCW06G10 User Manual
INSTALLATION
3
17
OPTIWAVE 1010
www.krohne.com
09/2014 - 4003537401 - MA OPTIWAVE 1010 R01 en
3.3 Transport
3.4 Pre-installation requirements
• Make sure that there is sufficient space on all sides.
• Protect the signal converter from direct sunlight.
• Do not subject the signal converter to heavy vibrations.
• Protect the signal converter from direct sunlight.
• Do not subject the signal converter to heavy vibrations.
3.5 Pressure and temperature ranges
WARNING!
•
Depending on the version, the device will weight approx. x...xx kg / xx...xx lb. To carry, use
both hands to lift the device carefully by the converter housing. If necessary, lift the device
with a hoist.
both hands to lift the device carefully by the converter housing. If necessary, lift the device
with a hoist.
•
When handling the device, avoid hard blows, jolts, impact, etc. to prevent damage.
INFORMATION!
Obey the precautions that follow to make sure that the device is correctly installed.
Obey the precautions that follow to make sure that the device is correctly installed.
DANGER!
If the ambient temperature is more than +70
If the ambient temperature is more than +70
°
C / +158
°
F, there is a risk of injury if you touch the
device. Use a protective cover or metallic grid to prevent injury.
Figure 3-2: Pressure and temperature ranges
1 Flange temperature
Non-Ex devices: Depends on the device versions (standard, HP and HT/HP versions) and the seal material. Refer to
the table that follows.
Ex devices: see supplementary operating instructions
the table that follows.
Ex devices: see supplementary operating instructions
2 Ambient temperature
Non-Ex devices: -40...+80°C / -40...+176°F
Ex devices: see supplementary operating instructions
Ex devices: see supplementary operating instructions
3 Process pressure
Depends on the type of antenna and process connection. Refer to the table that follows.