Linksys X1000 User Manual

 

This device complies with Part 15 of the FCC Rules. Operation is subject to 

the following two conditions: (1) This device may not cause harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. 

 

This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to Part 15 of the FCC Rules.    These limits 

are designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications.  

However, there is no guarantee that interference will not occur in a particular 

installation.  If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one of the 

following measures: 

 

-  Reorient or relocate the receiving antenna. 

-  Increase the separation between the equipment and receiver. 

-  Connect the equipment into an outlet on a circuit different from that 

to which the receiver is connected. 

-  Consult the dealer or an experienced radio/TV technician for help. 

 

FCC Caution: Any changes or modifications not expressly approved by the 

party responsible for compliance could void the user's authority to operate this 

equipment. 

 

This transmitter must not be co-located or operating in conjunction with any 

other antenna or transmitter. 

 

This equipment complies with FCC radiation exposure limits set forth for an 

uncontrolled environment. This equipment should be installed and operated 

with minimum distance 20cm between the radiator & your body.