Mobilicom ltd. MCU-30L User Manual
MCU-30 User Manual
Page : 30 / 51
This page contains information which is protected by copyright and is proprietary to Mobilicom Ltd.
No part of this document
may be used, copied, disclosed or conveyed to another party without prior written consent of Mobilicom Ltd
NOTE – Verify that each unit has a different unit ID
NOTE – In a Mobile MESH network configuration, the Number of Hops and
Max retransmit parameters should be set to 1.
Max retransmit parameters should be set to 1.
NOTE – unlimited amount of MCUs can use the same unit ID when in “listener
only” mode.
only” mode.
NOTE – A Mobile MESH network requires at least 2 MCUs configured with
same Transmission Vector, Frequency and Profile.
same Transmission Vector, Frequency and Profile.
9.2 MCU-30 LED indicator
By following the LED on the MCU the power and link status can be monitored, it is
described as follows:
described as follows:
• LED is ON – the unit is on, air link is down and no data is transmitted.
• LED blinks slowly –1 PPS signal is locked but there is no data over the link
• LED blinks fast – Air link is up and data is transferred over the air link
Link status, CINR, RSSI, Throughput and unit Log are available using the MC-EMA.