Mobilicom ltd. MSH-10 User Manual
User Manual
Page : 19 / 31
7.1 PTP Link Step-by-Step
Configuration
In order to build a PTP link, two SkyHopper Pro units are required. One unit acts as a remote unit,
while the other as a controller unit.
while the other as a controller unit.
1.
Connect antennas to RF1 and RF2 connectors, and power up the unit.
CAUTION – Powering up a unit without connecting the antennas can
cause irreparable damage to the unit.
cause irreparable damage to the unit.
2.
Connect the unit to a PC using a standard Ethernet Cat 5 cable.
3.
Set static IP in the 192.168.131.xxx subnet (For more information, see the Web GUI
Instructional Manual).
Instructional Manual).
4.
Using the Web GUI: Open a web browser installed on your PC / laptop (Chrome, Firefox,
Internet Explorer, etc.) and input in the address line: 192.168.131.241. That should connect
you to the Web GUI interface, as shown on Figure 6:
Internet Explorer, etc.) and input in the address line: 192.168.131.241. That should connect
you to the Web GUI interface, as shown on Figure 6:
Figure 6: Web GUI main screen
5.
To change the frequency to the required frequency, click on “Advanced Configuration” (third
tab on the left corner) and on the “Frequency” line and write the desired frequency within
the frequency range set in your unit.
tab on the left corner) and on the “Frequency” line and write the desired frequency within
the frequency range set in your unit.
6.
Set the profile as required (RF bandwidth, bitrate and ratio) and click on the “Apply” button
as shown on Figure 7. The unit will reboot.
as shown on Figure 7. The unit will reboot.
7.
Repeat stages 1-4 with the 2
nd
unit.