Hewlett Packard Enterprise Company APEX0102 User Manual

| Installation Guide

Assembly instructions for this part are shipped with the part. All instructions must be followed to 

ensure proper assembly of the connector onto the cable.
The required specifications for third party cable used with the CKIT solution are as follows:



AC power cable specifications (when using AC connector kit and custom cable): minimum voltage/

current rating 250V/1A, diameter 6-12mm, rated for outdoor use and UV exposure

1. Remove the weatherproof cap on the power interface. 
2. Insert the power cable connector into the power interface and hand-fasten the locknut. 

The integrated LEDs on the AP can be used to verify that the AP is receiving power and initializing 

successfully (see 

and 

). Refer to the ArubaOS Quick Start Guide for further details on 

verifying post-installation network connectivity.

Provisioning parameters are unique to each AP. These local AP parameters are initially configured on 

the controller which are then pushed out to the AP and stored on the AP itself. Aruba recommends 

that provisioning settings be configured via the ArubaOS Web UI only. Refer to the ArubaOS User 

Guide for complete details.

Configuration parameters are network or controller specific and are configured and stored on the 

controller. Network configuration settings are pushed out to the AP(s) but remain stored on the 

controller.
Configuration settings can be configured via the ArubaOS Web UI or ArubaOS CLI. Refer to the 

ArubaOS User Guide for complete details.

 Hot

Neutral

Ground