Hewlett Packard Enterprise Company MSR4000DFS User Manual
Aruba MSR4000 Wireless Mesh Router
| Installation Guide
25
6. Align the two installation holes on the two sides of the MSR4000 with the corresponding holes on the
mounting bracket and then use the two M6 x30 bolts (with flat and spring washers) to fix them. There is
screw thread in the screw hole of the solar shield.
screw thread in the screw hole of the solar shield.
Figure 27 Fixing the MSR4000 to the Mounting Bracket
Grounding the MSR4000
The grounding must be completed before powering up the MSR4000. The resistance of grounding wire
should be less than 5 ohm and the grounding cable’s cross-section area should be no less than 6 square
mm.The grounding hole is at the left side of the MSR4000.
should be less than 5 ohm and the grounding cable’s cross-section area should be no less than 6 square
mm.The grounding hole is at the left side of the MSR4000.
Figure 28 Grounding the MSR4000
1. Peel the cover of one end of the grounding cable (green or yellow and green grounding cable with 6 mm
cross-section area) and place the bare grounding cable into the copper lug, and press firmly with the
crimping pliers.
crimping pliers.
2. Fasten the copper lug to the grounding hole on the MSR4000 with the M4 x12 bolt and external-tooth
washer.
Connecting the RF Cable
The RF cable is used to connect the antenna and the MSR4000.
You must install the lightning arrester between the antenna and the MSR4000