SendFar Technology Co. Ltd. OAB-03001 User Manual
2.
Specify the Validity, Access Right and Community field.
2.
Specify the Version, IP Address and Community field.
- Validity
- Version
Select Enable or Disable to control this community.
Select Disable, Version 1 or Version 2 to control this trap host.
- Access Right
- IP Address
Select a command from the pull down menu for this field.
Enter the Trap Host IP Address.
- Community
- Community
Enter the password related the Access Right in this field.
Enter the password in this field.
3. Click
OK . To refresh the current community pool.
3. Click
OK . To refresh the current trap host pool.
4.
To modify another community entry to the current community pool,
repeat step 1 through step 3.
repeat step 1 through step 3.
4.
To modify another trap host entry to the current trap host pool, repeat
step 1 through step 3.
step 1 through step 3.
5.
When you have modified all the entries you need, click FINISH .
5.
When you have modified all the entries you need, click FINISH .
4.4 Configure Wireless related parameters
4.3.2 Configure Trap Host Pool
Select “/General Config/Wireless”. The Wireless LAN information page
appears as following figure.
appears as following figure.
The Trap Host Pool has five entries.
In here, enter the Channel (default is 1), rts Threshold (default is 1600),
frag Threshold (default is 1600), SSID (default is wireless) and Station
Name (default is ap) that are suitable for your radio network and then you
can clicked radio button to disable WEP or enable 64/128 bit WEP
services (default is disable), if WEP is enabled, you must input
corresponded Default Key index and WEP Key and then click KeyGen
to generate the WEP64 & WEP128 key patterns. After that, click FINISH at
the bottom of this page to complete the modification.
frag Threshold (default is 1600), SSID (default is wireless) and Station
Name (default is ap) that are suitable for your radio network and then you
can clicked radio button to disable WEP or enable 64/128 bit WEP
services (default is disable), if WEP is enabled, you must input
corresponded Default Key index and WEP Key and then click KeyGen
to generate the WEP64 & WEP128 key patterns. After that, click FINISH at
the bottom of this page to complete the modification.
1.
To modify a entry, click the select button beside the entry index
number and click Modify . The configuration page appears as
following figure.
number and click Modify . The configuration page appears as
following figure.
Version 1.00
28
Version 1.00
29