SendFar Technology Co. Ltd. OAP-02002 User Manual
16
4.2 System
Setup
When setting up a SendFar Wireless Access Router (OWAP), you must
decide which operation mode that your OWAP works. This feature is
available in the “/General Config/System/” page.
Figure 4-1 & 4-2 show the “General Configuration – System Setup”
page.
decide which operation mode that your OWAP works. This feature is
available in the “/General Config/System/” page.
Figure 4-1 & 4-2 show the “General Configuration – System Setup”
page.
Figure 4-1 General Configuration – System Setup-1
17
Figure 4-2 General Configuration – System Setup-2
Host Information
- Host Name. The Host Name is not an essential setting, but it helps
identify the device in network. Use this setting to assign a name to the
device.
identify the device in network. Use this setting to assign a name to the
device.
Operation Mode
The First Thing You Have To Do
Select an operation mode,
and click FINISH to refresh this page
.
Wireless Access Bridge
Select the Wireless Access Bridge mode. And then set the corresponding
parameters.
parameters.
- Bridge IP Address.
Use this setting to assign or change the bridge’s IP
address.