Redline Communications Inc. AN100UXA User Manual
User
AN-100U/UX Base Station
Manual
70-00058-01-04
Proprietary Redline Communications © 2010
Page 13 of 136
April 19, 2010
1.4
Deployment in the USA -- FCC Notices
Important Notice: Deployment in the USA (3650-3700 MHz Band)
The installer/end-user must install and activate the FCC-specific software version for
the AN-100U/UX base station before deploying wireless system.
the AN-100U/UX base station before deploying wireless system.
1.4.1 General FCC Notices
1.
The Model AN-100U / AN-100UX and its antenna must be professionally installed.
2.
WARNING -- FCC RF Exposure Warnings
To satisfy FCC RF exposure requirements for RF transmitting devices, a minimum
distance of 20 cm should be maintained between the antenna of this device and
persons during device operation. To ensure compliance, operation at closer than this
distance is not recommended. The antenna used for this transmitter must not be
collocated in conjunction with any other antenna or transmitter.
distance of 20 cm should be maintained between the antenna of this device and
persons during device operation. To ensure compliance, operation at closer than this
distance is not recommended. The antenna used for this transmitter must not be
collocated in conjunction with any other antenna or transmitter.
3.
Operation is available for the 50 MHz band 3650-3700 MHz (unrestricted contention
based protocol for WiMAX devices).
based protocol for WiMAX devices).
4.
FCC Information to Users @ FCC 15.21 & 15.105:
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
5.
Warning: Changes or modifications not expressly approved by Redline
Communications could void the user’s authority to operate the equipment.
Communications could void the user’s authority to operate the equipment.
1.4.2 Installation and Operation
FCC Part 90.1321 guidelines for deployment of RedMAX systems in the frequency band
of 3650-3700 MHz, for unrestricted CBP (Contention Based Protocol) in USA includes
restrictions on the maximum EIRP for sector controllers and subscriber units. To comply
with these guidelines, the following EIRP limitations are applied for deployment in this
band:
of 3650-3700 MHz, for unrestricted CBP (Contention Based Protocol) in USA includes
restrictions on the maximum EIRP for sector controllers and subscriber units. To comply
with these guidelines, the following EIRP limitations are applied for deployment in this
band:
i) Max EIRP of 25 Watts/25 MHz (equivalent to 1 Watt/1 MHz)
ii) Peak EIRP Power Density of 1 Watt in any 1 MHz slice of spectrum.
To ensure compliance with these restrictions, refer to the following important notices:
1. The 3650-3700 MHz frequency range is a licensed band in the USA and operators
must have a valid spectrum license to operate RedMAX equipment using this band.
2. The AN-100U/UX base station requires a Redline FCC-specific software load that is
mandatory for operation of the base station within the USA. This software enforces
the FCC approved operating range of 3650-3700 MHz.
the FCC approved operating range of 3650-3700 MHz.
3. The AN-100U/UX indoor unit, outdoor transceiver, and antenna must be
professionally installed.
4. Changes or modifications not expressly approved by Redline Communications could
void the user’s authority to operate the equipment.
5. The AN-100U/UX transmit power settings must not exceed values stated in the AN-
100U/UX User Manual.