iRiver EB05 User Manual

Page of 51
- FCC
This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. 
This equipment generate, uses and can radiate radio frequency energy and, 
if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. 
If this equipment does cause harmful interference to radio or television 
reception which can be determined by turning the equipment off and on, 
the user is encouraged to try to correct the interference by one or more of 
the following measures. 
-
Reorient or relocate the receiving antenna. 
-
Increase the separation between the equipment and receiver. 
-
Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected. 
-
Consult the dealer or an experienced radio, TV technical for help. 
-
Only shielded interface cable should be used. 
Finally, any changes or modifications to the equipment by the user not 
expressly 
approved by the grantee or manufacturer could void the users authority to 
operate such equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to 
the following two conditions: (1) this device may not cause harmful 
interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation
Caution : Any changes or modifications in construction of this device which 
are not expressly approved by the party responsible for compliance could 
void the user's authority to operate the equipment.
- CE
CE warning
!Changes and modifications not expressly approved by the party responsible 
for compliance could void the user's authority to operate the equipment.
EN Test Regulations
ETSI EN 300 328 V1.7.1/ ETSI EN 301 489-1 V1.6.1  / ETSI EN 301 489-17 V1.3.2  
EN 50332-1:2000 / EN 50332-2:2003
EN 60950-1:2006+A11:2009