Palmnet System Co. Ltd. PNS-816D User Manual

PNS-816D User’s Manual Draft 6/27/02 

                                   

16 

•  Use four M2x11 type machine screws to secure the modem to host board or other mounting 

surface (modem has a 2.5mm diameter hole in each 4 corner) 

•  May require washer and nut to secure the modem   

•  The length of the machine screw should be determine by each different application 

•  KYOCERA ELCO 30Pin 0.5Pitch Connector (Part Number: 08-6210-030-010-800A)   

•  0.5-30-80-D Flat Flex Cable (FFC): 30 pin, 0.5mm (centerline spacing), 80mm (cable length) 

•  The length of the FFC should be determined by each integrator’s application. 

•  Connector: Industry standard MMCX connector 

•  Antenna Cable: Low loss antenna cable with SMA screw-on connector is recommended 

•  Reflector could improve up to 20% of the antenna performance 

•  Antenna: An antenna with gain not exceeding 3 dBi should be used