Itron CENGPRS1 User Manual

 

   

 

 
 

SMR45-4601A  

10 

5.  When the SSI module inside the meter is fully configured with the customer specific information it 

will immediately send an Auto-Registration message to the customer’s TMS server. 

6.  If the meter successfully communicates with TMS the Registration message is processed and the 

meter sends a confirmation message back to the configuration server. 

7.  The meter is added/updated in the “Registration Group” under the Master List in TMS. 
8.  The meter is now in the “Placed” state. 
9.  The meter is ready to receive the Provisioning commands from TMS. 
10.  Once the meter is provisioned, meter data can be collected from the meter. 

 

 
The provisioning process must be completed to ensure the resulting transaction communication between 
the TMS and the device is correctly interpreted. If the provisioning process does not run to completion 
within 30 minutes, the TMS Operator should confirm that coverage validation procedures were properly 
followed and then review the PIN settings in the Device properties setup. 
 
Next, the operator should check the events in Monitoring Home>Event Search that have occurred within 
the time following the provision request.  
 
There should be a response within a short time period from the specified device showing the version of 
the SSI Module, since the Get Version transaction is the initial start of the provisioning process. Once the 
Get Version response is returned to the TMS for the TMS to determine certain attributes of the Device, 
the TMS sends a number of other transactions to the device to complete the provisioning process. 
 
If the Get Version does not complete successfully, check your Device PIN configuration. 
 
If there is no response of the initial provisioning transaction, follow the troubleshooting processes outlined 
in Section 4.  If unsuccessful, check the status of your local Internet connection, and then contact 
SmartSynch Customer Support for assistance.