Tagsys S.A. L200TUNANT500 User Manual
Using the L200 Explorer
November 2007
Revision 1.0
31/45
Figure 9: Debug Dialog Box
7.4 Standalone Mode Configuration
Standalone Mode is designed to use the reader without using any command set. While in this
mode, the reader is limited to tag reading.
mode, the reader is limited to tag reading.
The Standalone Configuration Mode dialog box is used to define all parameters of the Standalone
mode: chip type, frame format, baud rate, etc. For more information, please refer to
mode: chip type, frame format, baud rate, etc. For more information, please refer to
Section 8.2,
"L200 Reader Standalone
Mode
"
and the L200 Explorer User's Guide.
Requirements
: The STX-E GemCore
®
application, version 2.0 or more recent, must be
downloaded into the Lx00 Reader. In addition, the serial communication link must be used to
configure Standalone mode using the L200 Explorer.
configure Standalone mode using the L200 Explorer.