Tagsys S.A. MEDIOP101ETHER User Manual
Medio P101-Ethernet
24/41
Revision 2.2
April 2008
Power up and connect your Medio P101-Ethernet to a spare USB port on your PC. This should
bring up a “Building Driver Information Database” followed by the Windows Add New Hardware
Wizard.
bring up a “Building Driver Information Database” followed by the Windows Add New Hardware
Wizard.
Select “Search for the best driver for your device” and then click “Next”
Select “Specify a location” and click the Browse button to select the USB Drivers folder on
the Product CR-Rom. Once the files have been located, click “Next” to proceed with the
installation
installation
Click “Next” to install the device
Windows® should then display a message that the installation of the serial converter driver
was successful. The COM port emulation driver must now be installed. Click “Finish” to
complete the installation.
complete the installation.
To confirm that the installation has completed successfully, open the Device Manager and select
“View > devices by type”. The TAGSYS Medio P101 appears as an additional COM port.
“View > devices by type”. The TAGSYS Medio P101 appears as an additional COM port.
4.3.2 Windows XP USB Drivers Installation
Power up and connect your Medio P101-Ethernet to a spare USB port on your PC. This will launch
the Windows Found New hardware Wizard
the Windows Found New hardware Wizard
Select “No, not this time” and click next to proceed with the installation
Select “Install from a list or specific location (Advanced)” and then click “Next”
Select “Search for the best driver in these locations” and click the Browse button to select
the TAGSYS USB Drivers folder on the Product CR-Rom. Then click “Next” to proceed.
Windows should then display a message indicating that the installation was successful.
Click Finish to complete the installation
To confirm that the installation has completed successfully, open the Device Manager and select
“View > Devices by type”. The TAGSYS Medio P101 appears as a USB device connected to a
USB port.
“View > Devices by type”. The TAGSYS Medio P101 appears as a USB device connected to a
USB port.
The next step is to install the VCP drivers.
Power up and connect your Medio P101-Ethernet to a spare USB port on your PC. This will launch
the Windows Found New Hardware Wizard
the Windows Found New Hardware Wizard
Select “No, not this time” and click next to proceed with the installation
Select “Install from a list or specific location (Advanced)” and then click “Next”
Select “Search for the best driver in these locations” and click the Browse button to select
the USB Drivers folder on the Product CR-Rom. Then click “Next” to proceed.
Windows should then display a message indicating that the installation was successful.
Click Finish to complete the installation. This has installed the serial converter. The COM
port emulation driver must be installed after this has completed.
port emulation driver must be installed after this has completed.
After clicking “Finish”, the Found New Hardware Wizard will continue by installing the COM
port emulation driver.
To confirm that the installation has completed successfully, open the Device Manager and select
“View > Devices by type”. The TAGSYS Medio P101 appears as an additional COM port.
“View > Devices by type”. The TAGSYS Medio P101 appears as an additional COM port.
When the USB cable is plugged and communication is active, the ETHERNET module is
turned off.
turned off.