Tagsys S.A. WIFILIBINVREAD User Manual

 

 

 

WiFi Inventory Reader 

To reset the WiFi module 2 procedures are available: 

- 

Reboot the device: it is used to reinitialize the communication with the access point. 

- 

Reset the device to TAGSYS default factory settings: it is used when you can no more 
communicate with the reader due to incorrect WiFi settings. 

Both reset procedures are available by software via the WEB or TELNET interface. 

 

Reboot 

While the reader is powered, push the reset button with a thin object and 
release it. Wait for the reader start up. 

Reset To 

TAGSYS Factory 

defaults 

This procedure reset the entire device configuration (including network 
settings) to the TAGSYS factory defaults. 

- 

Unplug the reader power supply 

- 

Push the reset button 

- 

Plug the reader power supply 

- 

Keep the reset button pressed until the yellow LED blinks once and 
3 times. 

- 

Release the reset button 

- 

Unplug the power supply and plug it again 

- 

Wait for reader start up. 

 

The reset button is located underneath the WiFi Inventory Reader as shown in the picture below. A 
thin object such as a paper clip must be used to push the reset switch. 

.

 

 

June 2007 

Revision 1.1c 

19/36