Falcom GmbH BOLERO-LT User Manual
BOLERO-LT Hardware Description
Version 1.0.0
Casing :
➢
Fully shielded
Certifications
:
➢
Fully type approved confirming with R&TTE directive.
➢
CE, FCC, PTCRB, e1,IC.
Directive
:
➢
RoHS compliant.
Firmware
:
➢
Embedded TCP/IP stack (inc. TCP, IP and SMTP
protocol),
➢
Accessible via PFAL commands,
➢
Upgradeable via serial port and remotely over the air
(GPRS/TCP interface).
Memory :
➢
2 Mbyte FLASH for configuration, data-logging and
firmware storage
Serial ports :
➢
1 x full duplex serial communication
Serial Interface Setting :
➢
Full duplex serial communication, CMOS level
➢
2-wires (1 x Rx and 1 x Tx) for serial communication
➢
Baud rate on the serial port (user configuration).
➢
8 data bits, no parity, 1 stop bit, no flow control.
Evaluation kit :
➢
The BOLERO-LT Evalkit is designed to test, evaluate
and make basis configuration to enable remote
monitoring/configuration of the FALCOM BOLERO-LT. It
provides a sample configuration for application.
4.1.1 Power consumption
To be defined.
4.1.2 Operating temperatures
Parameter
Min.
Typ.
Max.
Unit
Storage temperature (without internal battery)
-40
+25
+90
°C
Operating temperature (without internal battery)
-40
+25
+85
°C
GSM
*
(without internal battery)
-30
+25
+80
°C
Charging temperature (with internal battery
enabled ***
)
0
+25
+45
°C
Discharging temperature (with internal battery
enabled ***
)
-20
+25
+60
°C
*
The extreme temperature can affect the sensitivity and performance of the GSM engine.
**
Using configuration $PFAL,Cnf.Set,DEVICE.BAT.MODE=
disabled
***
Using configuration $PFAL,Cnf.Set,DEVICE.BAT.MODE=
auto
Table 2: Operating temperature
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 16