Falcom GmbH FOX User Manual
FOX H
ARDWARE
M
ANUAL
- P
RELIMINARY
-
V
ERSION
1.0.0
6.3 LED’s description
The actual state of the FOX can be displayed by three LED’s on the front panel of
the unit. These programmable and accessible LEDs can be interfaced to the build-
in components to show their state. References how to customize the device
configuration can be found in the FOX software manual
“
the unit. These programmable and accessible LEDs can be interfaced to the build-
in components to show their state. References how to customize the device
configuration can be found in the FOX software manual
“
SteppIII_fox_bolero_lt_PFAL_Configuration_Command_Set.pd
f”
.
Figure 11:
View of LED indicators
6.4 Interface E (Mounting holes)
The FOX compact unit provides 4 holes for attaching it to a suitable location. As a
reference for mounting holes use
reference for mounting holes use
Fig. 12 below in this section.
The terminal can be mounted in different locations such as on wall or in vehicle,
metal or non-metal sheets.
In order to avoid any damage during mounting of the device, it is required to use
properly screws.
metal or non-metal sheets.
In order to avoid any damage during mounting of the device, it is required to use
properly screws.
There are no screws on the delivery pack.
Figure 12:
View of the mounting holes
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 26 of 31