Vivato Inc. VLJ24WFSW User Manual
Vivato 2.4 GHz Wi-Fi Switch User Guide
113
Command Line Interface
Read Level Command Descriptions
loop-back route. The flags “U” and “G” stand for “up” (status of the route) and “gateway ”,
respectively.
respectively.
show ip ssh
Displays the state of the secure shell (SSH) daemon: enabled or disabled.
show ip traffic-shaping
Displays the state of traffic shaping: enabled or disabled.
show logging
Displays a list of locally logged system events if logging has been enabled.
show memory
Displays information about installed memory and memory usage in the switch.
show pptp
Displays the status and configuration for point to point tunneling protocol (PPTP) security.
Figure 57—
Example “show pptp” Output
show rapd
Displays the SSID, MAC, channel number, and signal strength (dBm) of access points detected
at each pointing direction in the Wi-Fi Switch’s antenna pattern. The results for each detected
signal are only displayed for the channel with the greatest signal strength for any MAC address.
at each pointing direction in the Wi-Fi Switch’s antenna pattern. The results for each detected
signal are only displayed for the channel with the greatest signal strength for any MAC address.
Table 4—
Example IP Routing Information
Destination
Gateway
Genmask
Flags Metric
Ref
Use
Iface
145.88.47.9
195.145.3.150 255.255.255.0 UG
0
0
0
vlan3
195.145.0.0
0.0.0.0
255.255.255.0
U
0
0
0
vlan3
127.0.0.0
0.0.0.0
255.0.0.0
U
0
0
0
lo
Vivato(config)#show pptp
pptpSrvr Enabled
Auth:chap
CHAP SECRETS: XXXXXX
Listen:192.163.20.100
LocalIP:10.0.2.200
RemoteIP:192.163.20.1-99
MS-DNS primary: 10.0.2.245
MS-WINS primary: 10.0.2.240
Vivato(config)#
pptpSrvr Enabled
Auth:chap
CHAP SECRETS: XXXXXX
Listen:192.163.20.100
LocalIP:10.0.2.200
RemoteIP:192.163.20.1-99
MS-DNS primary: 10.0.2.245
MS-WINS primary: 10.0.2.240
Vivato(config)#