Young Electronics Corporation. EMS2YOUNG User Manual

or the receiver.(Note: The switches are in the "ON" positions

Alternating from "ON" and "OFF" or "OFF" and "ON" position.

order as the receiver for the transmitter to function properly.

It is important for the access code to be set exactly in the same

1. Standing approximately 10-30 feet away from the receiver,

2. Stand in several different areas of usage to locate possible

3. Using a sharp object or tool, such as a paper clip, set the new

according to the exact code setting of your previous transmitter

The,ACCESS310, is the mini transmitter designed for the garage

DIAGRAM #1

DOOR(GATE)
Open/Close

LIGHT
This LED lamp helps
you see the key lock.

DOOR BUTTON
OPERATION
INDICATOR

1. Determine the 10 digit access code obtained from the previous

2. Remove the two Philips head screws located on the back of the

Top Case Removed

Transmitter with

Code Switch

QUICK REFERENCE FOR

TRANSMITTER BUTTONS

ACCESS-310

Battery

door opener and gate operators for home,farm and ranch etc...

OPERATING INSTRUCTIONS:

transmitter or the receiver.

However there are over hundreds of combinations of codes
possible for you to choose from.

the circuit board and battery.(See Diagram #1)

case and carefully separate the case halves to expose

Code Setting

the following sequences are not recommended.

Testing the Transmitter

Setting the switch on all "ON" or all "OFF" position.

push the transmitter button to activate.

points where certain structures may interfere with
the transmission.

when the switch is pushed toward the letter ON.)

4. Once the codes have been set, replace the top cover,

Note: In order to avoid duplication of your access code,

and test the system.

2 3 4

6 7

(See Diagram #2)

DIAGRAM #2

Code Switch

PRODUCT INSTRUCTION

ACCESS 310 mini Transmitter

transmitter code by setting the "ON" and "OFF" switches

of this device which are not expressly approved by the

Caution: Any changes or modifications in construction

party responsible for compliance could void the user's

received, including interference that may cause undesired operation.

harmfull interference, and (2) this device must accept any interference

subject to the following two conditions: (1) this device may not cause

This device complies with Part 15 of the FCC Rules. Operation is

authority to operate the equipment.

2. Output Frequency : 300MHz

- Consult the dealer or an experienced radio/TV

different from that to which the receiver is connected.

- Connect the equipment into an outlet on a circuit

interference will not occur in a particular installation.
If this equipment does cause harmful interference to

by turning the equipment off and on, the user is

radio or television reception, which can be determined

- Increase the separation between the equipment

encouraged to try to correct the interference by one or

generates,uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that

provide reasonable protection against harmful
interference in a residential installation. This equipment

part 15 of the FCC Rules. These limits are designed to

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to

technician for help.

and receiver.

- Reorient or relocate the receiving antenna.

more of the following measures:

5. Lighting LED Lamp

3. Power Supply : 12Vdc(5Vdc Regulation)
4. Operation Indicate LED Lamp

J ELECTRONICS & CO.

C
TORRANCE CALIFORNIA

DISTRIBUTED BY

General specfication & Feature

1. Output Power : -37dBm