FreeWave Technologies Inc. 121819DEE521 User Manual
LRS-455-EU Data Transceiver Users Manual
LUM0032AA Rev A
Version 1.0
iii
UL
N
OTIFICATION
Models LRS-455-EU-C, LRS-455-EU-C-MS, LRS-455-EU-CE, and LRS-455-EU-CW
are suitable for use in
non-hazardous locations only. Input voltage for the above models is 6 to 30 volts DC.
WARNING: DO NOT REMOVE OR INSERT DIAGNOSTICS CABLE WHILE CIRCUIT IS LIVE UNLESS THE AREA
IS KNOWN TO BE FREE OF IGNITION CONCENTRATIONS OF FLAMMABLE GASES OR VAPORS.
IS KNOWN TO BE FREE OF IGNITION CONCENTRATIONS OF FLAMMABLE GASES OR VAPORS.
FCC
N
OTIFICATIONS
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1) This
device may not cause harmful interference and 2) this device must accept any interference received, including
interference that may cause undesired operation.
device may not cause harmful interference and 2) this device must accept any interference received, including
interference that may cause undesired operation.
This device must be operated as supplied by FreeWave Technologies, Inc. Any changes or modifications made to the
device without the express written approval of FreeWave Technologies may void the user's authority to operate the
device.
CAUTION:
The LRS-455-EU transceivers have a maximum transmitted output power of 2W. It is recommended that
the transmit antenna be kept at least 18.3 cm away from nearby persons to satisfy FCC RF exposure
requirements.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, no
guarantee shall be made that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Note:
Whenever any FreeWave Technologies module is placed inside an enclosure a label must be placed on the
outside of that enclosure which includes the module's FCC ID.
IC N
OTIFICATIONS
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Ce dispositif est conforme aux normes permis-exemptes du Canada RSS d'industrie. L'opération est sujette aux deux
conditions suivantes : (1) ce dispositif peut ne pas causer l'interférence, et (2) ce dispositif doit accepter n'importe
quelle interférence, y compris l'interférence qui peut causer le fonctionnement peu désiré du dispositif.
conditions suivantes : (1) ce dispositif peut ne pas causer l'interférence, et (2) ce dispositif doit accepter n'importe
quelle interférence, y compris l'interférence qui peut causer le fonctionnement peu désiré du dispositif.
Note:
The LRS-455-EU transceivers are approved for use in Canada within the 450MHz to 470MHz
band.