AeroComm Corporation PKLR2400-200 User Manual

11/24/03

DOCUMENT INFORMATION

Revision

Description

Version 3.6

Remove SDK developer kit information – 6/6/00
Re-arrange the layout of the specification to ease use
Correct Channels from 75 to 77 and provide range in Hex, Section 5.1.3

Version 3.7

6/28/00 – Made data rates uniform at 882 Kbps
Reformat I/O table to view additional line descriptions

Version 3.8

8/18/00 – Changed Input Voltage tolerance from 5% to 2%
Changed temperature from 0 – 60

C to 0 – 70

Changed Baud Low Default from F7 to F1
Updated Section 6 – API Command Set with examples & corrections
Added pin notations on Figure 1 - Mechanical Overview of AC5124C

Version 3.9

9/25/00 – Corrected DTR pin number from 33 to 34, Pin 33 is NC
Changed Pin 24 from Reserved to NC
Remove Note from the CTS timing diagram in Sections 3.3.1 & 4.6
Changed description for Diagnostic Result command in Section 6.1.3

Version 4.2

10/25/01 - Changed PKLR2400S part number to AC5124C
Added AC5124C-200 information
Added Section 3.3, Electrical Specifications
Added RSSI calibration steps in Section 3.2.1
Added Section 4.6, Addressed & Broadcast Communication
Added Section 4.7, Handshaking
Updated Table 6, EEPROM Parameters to include new parameters
Updated Section 5, API Command Set to include command examples
Updated Section 6, Configuring the AC5124C to include new parameter definitions
Added Section 7, Initializing the AC5124C Transceiver
Updated Section 8, Mechanical Overview to include new drawings

Version 4.3

3/25/01 – Changed Interface Timeout values in Table 6, EEPROM Parameters
Updated RF Mode 1 (EEPROM Address 4Ch) to include new definition for Bit 7
Added Section 6.1.15.5, Mixed Mode
Updated Approved Antenna List

Version 4.4

11/24/03 – Updated all references to operating temperature from 0

C to 60

C to -40

C to

C. All AC5124 products are industrial temperature. Added AT Commands for

reading and writing the EEPROM. Updated RSSI plot for new receiver IC.