AeroComm Corporation PKLR2400-200 User Manual

AC5124-10 Specifications

AC5124-10 Specifications

AC5124-10 Specifications

AC5124-10 Specifications               

               

               

                                               

                                

                                

                                                        

                        

                        

                            

11/24/03

35

6.2.7

6.2.7

6.2.7

6.2.7  Write EEPROM Byte

Write EEPROM Byte

Write EEPROM Byte

Write EEPROM Byte

EEPROM Writes are performed one byte at a time.  To write a byte of EEPROM, the OEM Host should
issue the following command to the radio (NOTE:  before sending this command, the EEPROM Write
Enable pin must be Low):

ATWXX=YY

↵

Where XX is equal to an EEPROM address.  If the address is less than 10H, the leading zero must still
be sent such as ATW05=YY

↵

Where YY is equal to the value to store in the EEPROM location.  If the value is less than 10H, the
leading zero must still be sent such as ATWFE=0F

↵

Where 

↵

 is equal to 0DH (13 decimal).

If it successfully receives the command, the radio will issue the following response to the OEM Host:

OK

↵

Where 

↵

 is equal to 0DH (13 decimal).

If it is at least able to receive the 

↵

 character but there is an error in the command or part of the

command is missing, the radio will issue the following response to the OEM Host:

ERROR

↵

Where 

↵

 is equal to 0DH (13 decimal).