Capital Prospect Ltd AM001 User Manual
Zone Dependent Setting – Beep / Alarm
r can customize the audio warning so that when a sensor is triggered, it may bee
se
secu
•
alarm
immediately, but it will stop when the sensor is back to normal (door closes). It
umbers since it is not armed.
without entry delay, it is called
tered.
l z
the factory.
•
•
or is not located outdoor
1. Pre
th
2. Enter the current Master Password. Control panel will emit 3 beeps if the valid password is
3.
ents the current beep / alarm
setting.
•
If the zone LED flashes, that ind
the zon
rammed to “Beep”.
•
If the zone LED remains steadily on, that indicates the zone is programmed to
“Alarm”.
“Alarm”.
4. To change the setting between beep and alarm, press buttons 1 to 5 will set that zone to
beep. Pressing buttons 6 to 0 will set
o ala
to Fig X. After making the
change, notice the stat
zone
es a
Beep Alarm
U
p, or an
alarm may sound immediately. Depending on whether the control panel is in alert mode or
rity mode, the audio warning will be different.
Alert mode: If a sensor is triggered (i.e. opening a door) with the alarm feature on, the
will sound
control panel will not call the emergency phone n
will sound
control panel will not call the emergency phone n
Security mode: If a sensor is triggered (i.e. opening a door) with the alarm feature on and
•
the system is armed, the siren will sound immediately
“Instant Alarm”. The siren will not stop until the siren timeout or a valid password is en
Control panel will call the emergency phone numbers to notify the users of the alarm
situation.
“Instant Alarm”. The siren will not stop until the siren timeout or a valid password is en
Control panel will call the emergency phone numbers to notify the users of the alarm
situation.
l ones were programmed to beep at
A
It is recommended to program a zone into Alarm mode if:
It is recommended to program a zone into Alarm mode if:
•
You need immediate attention if that sensor is triggered, such as flood sensor, smoke
sensor etc.
The sensor will not be triggered on a daily basis
The sens
sensor etc.
The sensor will not be triggered on a daily basis
The sens
ss e [PROG] button on the side of the control panel, the [PROG] LED will be on.
entered, otherwise a single long beep will be emitted and [PROG] LED will be off.
Enter [5], which represents “Beep / Alarm” setting. Notice all 5 zone LEDs, some of them
may be off, some of them may flash. The LED flashing repres
Enter [5], which represents “Beep / Alarm” setting. Notice all 5 zone LEDs, some of them
may be off, some of them may flash. The LED flashing repres
icates
e is prog
that zone t
rm. Refer
us of the
LED chang
s well.
Zone 1
Button [1]
Button [6]
Zone 2
Button [2]
Button [7]
Zone 3
Button [3]
Button [8]
Zone 4
Button [4]
Button [9]
Zone 5
Button [5]
Button [0]
5. You are allow to make unlimited changes before programming is quit. Once you are
satisfied with the settings, press [PROG] to quit programming and the settings will be saved.