ATAG MC3292C User Manual

147

Induction Hob Installation

Induction Hob Installation Guide

ATAG Induction hobs have air vents on the under side 

of the appliance, at the front and bottom. To allow the 

hob to vent from the front a 3 mm gap is recommended 

between the bottom of the work surface and the top 

of a drawer front or ATAG 600 mm Single Oven that is 

installed beneath the hob.

Please see the diagram below:

If an ATAG Induction Hob is installed in an extra deep 

work surface or in a handleless kitchen the hob will 

automatically vent from the bottom.

Please see the diagram below:

Under these circumstances if there is limited space 

beneath the hob, due to a drawer or single oven 

installation, it is recommended that ‘air holes’ be cut into 

the cabinetry directly beneath (to the left, right and rear) 

of the hob.

When installing an ATAG Induction Hob above an ATAG 

600 mm Single Oven it is not necessary to provide 

additional ventilation space or heat protective shields 

beneath the hob/above the oven. 

Please note that when an ATAG Induction Hob is 

installed above an ATAG 900 mm Single Oven additional 

ventilation space and heat protective are required, refer 

to the User Care/Installation Guide for more information.

Please see the diagram 

below for the required air 

flow/direction when an 

ATAG Induction Hob is 

installed above a drawer:

Please see the diagram 

below for the required air 

flow/direction when an 

ATAG Induction Hob is 

installed above an ATAG 

600 mm Single Oven:

3 mm