Wistron NeWeb Corporation A18QA User Manual
UMC-A18QA Product
Specification
Page 4
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the user‘s authority to operate the equipment.
compliance could void the user‘s authority to operate the equipment.
End Product Labeling
The final end product must be labeled in a visible area with the following: “Contains FCC ID:
NKRA18QA”. The grantee's FCC ID can be used only when all FCC compliance requirements are
met.
NKRA18QA”. The grantee's FCC ID can be used only when all FCC compliance requirements are
met.
RF Exposure Information
This device is intended only for ODM/OEM integrators under the following conditions:
(1) The antenna must be installed such that 20cm is maintained between the antenna and users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) To comply with FCC regulations limiting both maximum RF output power and human
exposure to RF radiation, the maximum antenna gain including cable loss in a mobile exposure
condition must not exceed:
(1) The antenna must be installed such that 20cm is maintained between the antenna and users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) To comply with FCC regulations limiting both maximum RF output power and human
exposure to RF radiation, the maximum antenna gain including cable loss in a mobile exposure
condition must not exceed:
Standalone Condition:
1.0 dBi in 700 MHz Band
1.5 dBi in 850 MHz Band
5.5 dBi in 1700 MHz Band
3.5 dBi in 1900 MHz Band
IMPORTANT NOTE:
This module is intended for ODM/OEM integrator. The integrator is still responsible for the
FCC compliance requirement of the end product, which integrates this module. 20cm
minimum distance has to be able to be maintained between the antenna and the users for
the host this module is integrated into. Under such configuration, the FCC radiation exposure
limits set forth for an population/uncontrolled environment can be satisfied.
FCC compliance requirement of the end product, which integrates this module. 20cm
minimum distance has to be able to be maintained between the antenna and the users for
the host this module is integrated into. Under such configuration, the FCC radiation exposure
limits set forth for an population/uncontrolled environment can be satisfied.
Any changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate this equipment.
user's authority to operate this equipment.