Data Critical Corporation AVTS1010 User Manual
AlarmView™ System User’s Guide
{insert part #} Page 24
Tap Exit button {insert exit button} (< in upper left corner of screen) to
return to SysMgr Main Screen from submenus.
Tap Scroll buttons {insert scroll buttons} to move left and right to make
tabs visible in submenus.
Tap Down Arrow to reveal pull-down menu choices.
Changing System Parameters
AlarmView System parameters are set and transmitters are configured
during to your specific site during initial system installation.
Only Qualified personnel should use the AlarmView Install Program
software to view and change system configuration and parameters that
cannot be changed with the SysMgr program.
The Install Program has five main screens: Password, Alarms, Pagers,
Monitors, and Sys Inf (system information), which are used to change
the following parameters.
♦
Default program password (DCC)
♦
Bed Numbers (up to 48)
♦
Pager Cap Codes (up to 12)
♦
Alarm Pager Destinations (1, 2, or all pagers)
♦
Bed Number and Pager Assignments
♦
Transmission Frequency (MHz) and Baud Rate (bps)
♦
Global Pager Cap Code
♦
Reminder Page Delay Interval
♦
Survey Page Interval and Duration
!
!
!
!
!
!
Some of the above can also be accessed and changed through
the SysMgr main program.
the SysMgr main program.